 |
Shaft-to-Flange
(TF Series)
The TF series features shaft-to-flange configuration
with a center pilot for mounting sprockets, fixtures
and dial plates. Since the miniature units are
included in this series, a large variety of torque
ranges are offered. Washdown and clean room compatible
models are available. Compatible with our shaft
output indexing units.
|
 |
Shaft
Coupling (TC Series)
The TC series performs shaft-to-shaft coupling
with the same misalignment characteristics as
a flexible coupler. This series can compensate
for shafts with angular error, end to end spacing
and shaft parallel offset. Miniature sizes, washdown
and clean room compatible models are available.
Compatible with our shaft output indexing units.
|
 |
High
Capacity (TAD Series)
The TAD series is an economical flange-to-flange
configuration with a center pilot for mounting
fixtures and dial plates. Features include heavy
unbalanced loading capability, multiple springs
offer various torque ranges. Compatible with hollow
bore indexing units.
|
 |
Flange-to-Flange
(To Series)
The To series is flange-to-flange configuration
with a center pilot for mounting fixtures and
dial plates. Designed to be low profile and accommodate
heavy unbalanced loads, multiple springs offer
various torque ranges. Compatible with hollow
bore indexing units.
|
 |
High-Speed
(TR Series)
The TR series has shaft-to-shaft coupling with
misalignment error compensation, same as a flexible
coupler. When this unit trips for overload, it
must be reset manually requiring human interface.
Compatible with our shaft output indexing units.
|
 |
Low
Torque Range (TRF Series)
The TRF series offers small torque capacity with
fast acceleration speeds and rotations speed up
to 2000 rpm. Commonly used for motors driving
small machinery. The shaft-to-flange center pilot
can mount sprockets, fixtures and dial plates.
Compatible with our shaft output indexing units.
|
 |
High
Frequency (TNF Series)
The TNF series is designed for frequent overload
tripping with low speed applications up to 800
rpm. The shaft-to-flange configuration incorporates
a center pilot for mounting sprockets, fixtures
and dial plates. Compatible with our shaft output
indexing units.
|
 |
Air
Adjust (TAF Series)
The TAF series utilizes compressed air to adjust
the torque capacity instead of a spring. A perfect
choice for uncoupling machinery on the fly. The
shaft-to-flange center pilot can mount sprockets,
fixtures and dial plates. Compatible with our
shaft output indexing units.
|
 |
Linear
Torque Limiter (LM Series)
The LM series incorporates a detent ball &
pocket with adjustable spring tension forcing
the ball in the pocket. Piggyback mounting with
dual units can supply protection in both axis
planes. Overload monitoring is available with
compatibility to our linear handler units.
|
